It has recently occurred to me that I do all my work by myself. That makes me a DIAer, not a DIYer. What is the difference, you ask? My definition of a do-it-yourselfer is a person who builds, modifies, or repairs things without the direct aid of experts or professionals, but perhaps with the aid of others. A do-it-aloner works alone. Is this a problem? Not usually, but sometimes…
Cutting plywood is very difficult to do alone
- How to figure out how much plywood to buy. This requires a bit of math. Measure the dimensions of your wall. For instance, my wall was 24 feet wide and 7.5 feet tall. To get the square footage of the wall, multiply those two numbers together; 24 X 7.5 = 180. Plywood is 4 X 8 or 32 square feet. To determine the number of pieces you need, divide the square footage of the wall, by the square footage of the panel. 180 divided by 32 is 5.6. So I purchased 6 pieces of plywood.
- Have the plywood delivered. Here is a great hint. If you open a Lowe’s American Express Business Card, you can get your purchases delivered for $20 instead of the regular $60. You also get 5% off every purchase.
- Getting the plywood on the table saw. Handling a full size sheet of plywood can be problematic. I found that I could maneuver a piece onto the saw, but it quickly wanted to twist, turn and fall off! In order to stabilize the sheet and hold it steady, I decided to build myself a couple of helpers, one to to catch the plywood after it went through the saw, and another to hold the plywood on the left side and keep it level. Without this support, I wouldn’t have been able to maintain a steady rate of speed as the piece went through the saw. I made a catch table from a couple of saw horses with an old door on top. Nothing fancy, but just the right height! Then I scrounged around and found a couple of chairs that worked to hold up the plywood on the left side of the saw. Great, I had two helpers!
- Start cutting. I was really careful cutting the plywood. My kids were counting my fingers when they came to visit. Every time! I set the fence on the saw at 5 and 7/8 inches so that I would get 8 equal pieces. With such a large piece, it was difficult to put equal pressure from the end and the left side of the piece. Turn on the saw. Yikes. I pushed it through slowly, making sure the edge of the plywood was always tight against the fence. Amazingly, that first piece was perfect! Phew! Each cut got easier after that as the plywood got smaller and lighter.
- Feel terrifically proud!
After using the table saw I still have all 10!